![lsi raid drivers for windows 10 lsi raid drivers for windows 10](https://newaholic.weebly.com/uploads/1/2/5/3/125372867/286364557.jpg)
**Do you get any specific error and have you created a RAID array from the disks attached to the controller? I've read that, but there isn't info that I need there.ġ) Has anybody make SATA RAID works under ESX 3.x?Ģ) If linux driver won't work, what driver I shall download? Or it means, once I configure the hardward RAID, ESX shall just let it go? Seems not. I got both the same error like "driver not found" (I will catch the exact word of the error message after I go home today.), then you got chance to manually select the driver from drop-down list, or choose have disk.
LSI RAID DRIVERS FOR WINDOWS 10 INSTALL
I tried both configure hardware RAID (by ctrl+M) before installing ESX, or install ESX without pre-configured RAID. The P5K has only an Attansic Ethernet controller onboard, which isn't supported either. However, for net based installations - and for having net access once ESX is up and running - you have another roadblock to overcome. Trust me on this: You are going to have to look into another installation method, like NFS, FTP, or a temporary SCSI CDROM. There is no driver for the J-Micron controller and therefore the service console is unable to find the file stage2.img, which contains the second stage of the installer. Which needs drivers for any hardware that it is going to access. Yes, the first stage of the installer will certainly boot from your CDROM drive through BIOS support, but then the service console starts. That's because the J-Micron controller (which also happens to run that single IDE port) is in fact a RAID controller and the service console can tell because it is reading the PCI device type. All the items in that list are RAID controllers. Because when it reports this error, it gives options to manually select the driver. I think this message shall not for the CDROM. Only this CDROM are attached to this port. I attatch it to the only IDE port on P5K Green. Regarding the CDROM, I was using an old CDROM from another old Compaq system. What is your current 150-4 firmware version? The currently firmware version is 713R, there is newer version 713S released since.